Cable Kolink extension 3 Pin for 5V ARGB PGW-AC-KOL-041

This Kolink cable is simple, but a useful accessory if you want to organize ARGB lighting in your case without acrobatics with short cables. It is an extender for 3 PIN 5V ARGB, which gives you more freedom where to place fans, strips or other addressable RGB devices. Length of 500 mm is fully sufficient to reach from the bottom or controller to the front panel, the bottom of the case or top-mounted fans. The black color helps to blend with the rest of the cable management and not shine excessively in the glass panel.

What you get is a clean extender for addressable RGB, without unnecessary extras – exactly what you need if your connectors are physically far from the devices. The connector is a standard 3 PIN 5V ARGB Header, so it works both directly on the motherboard and via an external RGB controller. At 500 mm length you can run the cable behind the tray, tie it with velcro or zip ties and keep the front of the case clean. Support for addressable RGB means that each individual LED in the strip/fan can keep its effects via the motherboard or controller software – the extender does not limit them.

• Extending cable with length 500 mm, which gives you enough space for clean cable management in most mid and full tower cases.
• Standard connector 3 PIN 5V ARGB Header, compatible with both the motherboard and an external RGB controller.
• Intended for RGB lighting, so it is aimed at fans, strips and other ARGB accessories, not for powering fans as such.
• Support for Addressable RGB, which means that it preserves individual control of LEDs and effects via software.
• Categorized as RGB controller accessory, it fits well with existing controllers and hubs in your system.
• In black color, which helps the cable to remain discreet in a case with a transparent side panel.
• 24 months warranty, so you are assured for long-term use with frequent moving and reorganizing of builds.

This cable is suitable if you have ARGB fans or strips, but the header on the motherboard or controller is far and you do not want to pull cables through the entire front of the case. Ideal for organized builds with good cable management and for cases where you want to bring ARGB to hard-to-reach places. There is no point in buying it if you work only with 12V 4 PIN RGB or if you do not have addressable lighting at all.

The combination of a standard 3 PIN 5V ARGB connector, reasonable length 500 mm and a clean black design makes this Kolink extender small, but a very practical piece of the puzzle for an organized and well-lit build.