Gamemax FN12A-N2 WL-RW Reverse Fan Pack 3-in-1 3x120mm, Daisy-Chain, A-RGB, White Fan Kit

Gamemax FN12A-N2 WL-RW is a kit of three 120 mm fans for the case, aimed at gaming and enthusiast configurations where you want simultaneously good airflow and a neat, clean look. You get reverse rotation, which is convenient for front intake with the "beautiful" side facing out, without sacrificing airflow. The fans have PWM control via 4-pin connector and support Addressable RGB lighting for synchronization with the rest of the components. The combination of up to 2000 RPM, 58.6 CFM and 1.98 mmH2O makes them suitable even for denser mesh front panels.

What you get

With a range of 800 – 2000 RPM you can tune them from a quiet mode for idle and light load to more aggressive cooling at load. The airflow of 58.6 CFM per fan is fully sufficient for a solid front intake or exhaust, while the static pressure of 1.98 mmH2O helps air pass through filters and denser panels. At up to 30.6 dBA noise, in a normal gaming scenario, especially with active PWM control, the system remains relatively quiet. Reverse direction of rotation allows you to mount the fans so that you see the RGB side, but the airflow is directed in the correct direction for cooling. With Hydraulic Bearing and MTBF of 30000 h you get a reasonable balance between longevity and price.

• The kit includes 3 x 120 mm fans, which is enough for full primary cooling of a typical mid-tower case (front intake + rear exhaust or front 3x intake).
• The size 120 x 120 x 25 mm is standard, so the fans fit without problems in most cases and radiators that accept 120 mm.
• The range of 800 – 2000 RPM with PWM control via 4-pin connector gives you fine control via the motherboard or software fan curves.
• Airflow of 58.6 CFM and static pressure 1.98 mmH2O ensure effective cooling even through dusty filters and denser front panels.
• Maximum noise level 30.6 dBA is reasonable for a fan that reaches 2000 RPM, especially if you set a profile with lower RPM at idle.
• Addressable RGB lighting with 3 pin ADD-RGB 5V (V-D-NC-G) connector allows you to synchronize colors with the motherboard and other A-RGB components.
• Reverse rotation direction is optimal if you want the fans to look good from the front and still push air into the case, without looking at the "ugly" back side.
• Hydraulic Bearing and MTBF 30000 h ensure decent reliability for long-term 24/7 operation in gaming or office configurations.
• Low consumption – only 0.18 A, 12 V DC and 2.16 W per fan – spares the power supply and facilitates control via the motherboard.

Who it is suitable for

This kit is suitable if you are building a gaming or show build with a window and want a neat look with RGB and flat fans from the front. It fits well on white cases and configurations where design is just as important as cooling. If you are looking for absolutely silent fans at low RPM or the highest class bearings and extreme MTBF, you can look at more premium models.

The most sensible thing here is the combination of reverse design, A-RGB and PWM control in a kit of three fans that can actually take over the entire primary cooling of your case without unnecessary complications.