Fans CORSAIR RS120 Reverse ARGB 120mm ARGB Fan Triple Pack - CO-9050196-WW

This fan kit Corsair RS120 Reverse ARGB 120mm is aimed at people who want organized airflow and a clean ARGB build, without sacrificing noise or efficiency. You get a triple pack of 120 mm fans with reverse rotation direction, which is especially convenient for front intake with visible ARGB from the outside. The Magnetic bearing helps for quieter and longer-lasting operation, and the speed of 420–2100rpm gives you a wide range between nearly silent idle and serious airflow under load.

What you get

You have three 120 mm fans, each with a thickness of 25 mm, making them compatible with most cases and radiators when used as a case cooler or radiator cooler. The airflow range of 22.6–111.84m³/​h (13.3–65.82 CFM) allows you to use them from light blowing in a silent profile to serious exhaust of hot air from a powerful gaming build. The static pressure up to 2.81mmH₂O is important if you are going to place them behind dense mesh panels or on a radiator – it helps the air actually pass through the fins and filters. The noise level of 10–34.6dB(A) means that at low speeds they are almost inaudible, while at maximum you get the full cooling potential, but you must already accept a bit more sound.

• Size 120 x 120 x 25 mm – standard form factor that fits most PC cases and 120 mm radiators.
• Speed 420–2100rpm – a large range that allows you to set a profile from completely quiet to aggressive cooling as needed.
• Airflow 22.6–111.84m³/​h (13.3–65.82 CFM) – sufficient for both a light airflow build and a hotter system with a powerful GPU and CPU.
• Static pressure 0.14–2.81mmH₂O – suitable for mounting behind filters, dense panels, or on radiators where resistance is higher.
• Noise level 10–34.6dB(A) – from nearly silent operation at low speeds to maximum cooling when everything in the case is under load.
• Magnetic Bearing – improves fan life and reduces vibrations and noise compared to cheaper solutions.
• Addressable RGB with 3 pin ADD-RGB 5V (V-D-NC-G) – full control over lighting via a compatible controller or motherboard, synchronized with other ARGB components.
• Reverse rotation direction – designed so that the ARGB side faces you, even when the fan operates as intake through the front panel.
• 4 pin connector – standard PWM speed control via motherboard or fan hub for more precise control of noise and temperature.
• Kit of 3 units – sufficient for a full front intake, or a combination of front + top/radiator in a mid-sized build.
• Warranty 60 months – long-term peace of mind for the entire fan setup.

Who it is suitable for

It is suitable if you are building an ARGB build and want the fans to look good from the visible side, especially with mesh front panels and a glass side panel. It works for both gaming configurations with more serious heat dissipation and for quieter, balanced systems with control over speeds. If you are aiming for a super minimalist build without any lighting, the ARGB components here will simply not bring you added value.

The combination of reverse design, wide speed range, and magnetic bearing makes this triple pack Corsair RS120 Reverse ARGB a very flexible solution for cooling and the look of your case in the long term.