Thermalright TL-M12QR Fan Pack 3-in-1 3x120mm Reverse, Infinity Mirror, Daisy-Chain, A-RGB

Thermalright TL-M12QR Fan Pack 3-in-1 is a set of three 120 mm case fans, aimed at mid-range and more serious builds where you seek a good balance between airflow, noise, and looks. You get a 120 mm form factor with actual physical dimensions of 124 x 120 x 25 mm, which means compatibility with most standard cases. The 500–2000 RPM range gives you flexibility – from quiet idle to more aggressive cooling under load. The black color and A-RGB lighting with an Infinity Mirror effect make the kit suitable if you want a clean but visually strong look.

What you get: three Thermalright fans with an S-FDB Bearing, designed for quieter operation and better longevity compared to standard sleeve bearings. With a maximum of 47.6 CFM and a static pressure of 1.31 mmH2O, you can expect stable airflow for a front intake or top exhaust configuration. The noise level of up to 23.2 dBA is suitable if you want a quiet system, especially at lower RPMs controlled via 4-pin PWM. The 3-pin 5V ADD-RGB connector allows you to connect the lighting to a motherboard with addressable RGB and synchronize the effects with the other components. Daisy-chain connection simplifies cable management – fewer cables to the motherboard and a cleaner interior.

• A set of 3 x 120 mm fans, sufficient for a full intake or a combined intake/exhaust setup in most ATX cases.
• A 500–2000 RPM range, which gives you a choice between quiet operation at low speeds and more serious cooling under load.
• Maximum airflow of 47.6 CFM, suitable for improving overall case airflow and lower CPU and GPU temperatures.
• Static pressure of 1.31 mmH2O, which helps air pass more easily through filters and denser mesh panels.
• Low noise level of up to 23.2 dBA, so the system remains relatively quiet, especially with a proper PWM curve.
• S-FDB Bearing for smoother rotation and better durability compared to basic solutions.
• Addressable RGB (3-pin 5V) with an Infinity Mirror effect, allowing you to fine-tune the look and synchronize it with the rest of the A-RGB lighting.

This kit is suitable if you are building a gaming or work build in a mid-tower or full-tower case and want both stable airflow and noise control. If you are pursuing extreme overclocking configurations with many radiators and very dense filters, you will likely need fans with higher static pressure, but for mainstream gaming and workstation configurations, these will perform excellently.

The combination of three fans, a wide RPM range, S-FDB bearings, and A-RGB with Infinity Mirror makes them a practical choice if you want both functional cooling and a good-looking case interior.