Thermal pad Thermal Grizzly Minus Pad Extreme 120 x 20 x 1.5 mm

Thermal Grizzly Minus Pad Extreme 120 x 20 x 1.5 mm is a high-class thermal pad aimed at people who want maximum cooling instead of "whatever is available". With thermal conductivity 22 W/mk and a convenient size 120 x 20 mm, this is a solution for serious enthusiasts who tinker with VRM, VRAM, M.2, and custom cooling. The thickness of 1.5 mm helps to compensate for uneven surfaces and gaps between the heatsink and chips. Without unnecessary extras, just aggressive thermal behavior for components that run hot.

What you get
With this thermal pad, you can replace the factory soft and often low-quality pads on graphics cards, motherboards, or SSD coolers with something far more effective. 22 W/mk means that heat is transferred much faster to the heatsink, which helps achieve lower temperatures under heavy load. The size 120 x 20 mm gives you enough material to cut to size for several VRAM chips or entire VRM sections. The thickness of 1.5 mm is particularly convenient when there is a larger gap between the component and the heatsink, and standard thin pads simply do not make good contact. This is a typical "take, cut, place" product, with no need for special tools or preparation.

• The manufacturer Thermal Grizzly is focused on cooling for enthusiasts, so this thermal pad is aimed at more serious modifications and upgrades.
• The type thermal pad allows for easy installation and removal compared to thermal paste, especially with VRAM, VRM, and other SMD components.
• The thermal conductivity of 22 W/mk is very high for a thermal pad and helps in more effectively dissipating heat to the heatsink or cooling block.
• The size 120 x 20 mm is convenient for cutting strips and blocks for graphics cards, motherboards, and M.2 coolers.
• The thickness 1.5 mm is suitable when there is a larger gap between the chips and the cooling element and you need to fill in unevenness.
• Product code TG-ZUWA-230 makes it easy to find the same model for future upgrades or replacements.
• The lack of warranty (0 months) is standard for consumables of this type, which are considered single-use installations.

Who it is suitable for
It is suitable for people who disassemble cards, tinker with cooling, and want to lower temperatures of VRAM, VRM, or SSD above the standard level. It is also a good choice if you are doing custom cooling or refreshing an old GPU with hard and worn factory pads. If you are just looking for a cheap pad "just in case", this solution may seem too serious and excessive.

The combination of high thermal conductivity 22 W/mk, practical size, and thickness 1.5 mm makes this thermal pad a very flexible tool for cooling hot components. You take one sheet, cut to size, and give your hardware the air to operate more calmly.