1stPlayer R1 Bulk Fan 120mm

1stPlayer R1 Bulk Fan 120mm is a basic 120 mm case fan aimed at budget builds and upgrades where you seek just decent airflow and a bit of color in the case. It operates at 1100 RPM, making it rather moderate in speed, not a “turbine.” You get 38.9 CFM airflow and Fixed RGB lighting for a bit of ambience without the need for additional control. The connector is 3 PIN, so it easily connects to standard fan headers on the motherboard.

What you get

With a size of 120 x 120 x 25 mm, the fan fits the most common positions for front/rear case fans. At 1100 RPM and a consumption of only 2.52 W (at 12 V and 0.21 A), the load on the power supply and motherboard is minimal, so you can safely install several of these in one system. The Sleeve Bearing is typical for this class – good enough for vertical mounting and normal use. The Fixed RGB lighting is constant, without complex modes and software, just plug it in and it lights up. The black casing visually fits most builds and does not dominate the other hardware.

• Standard size according to standard 120 mm, making it compatible with most cases on the market.
• Airflow of 38.9 CFM, suitable for general improvement of airflow in the case.
• Speed of 1100 RPM, balanced for moderate cooling without extreme speeds.
• Uses Sleeve Bearing, typical for budget fans and sufficient for standard use.
• Operates at 12 V with a consumption of 2.52 W and current 0.21 A, which is easy for any standard fan header.
• Connector 3 PIN, suitable for connection to the motherboard with basic speed control (voltage control).
• Fixed RGB lighting, which provides a color effect without the need for additional software or controllers.
• Color black, to remain neutral and clean in most builds.
• 24 months warranty, giving you peace of mind for long-term use.

Who it is suitable for

This fan is suitable if you are building a budget gaming or office computer and need basic cooling for the case with a bit of RGB vision without complex settings. It is also a good choice if you simply want to add another 120 mm intake or exhaust fan to an existing system. It is not the best option if you are aiming for maximum airflow for a very hot high-end build or full control of lighting.

The combination of standard 120 mm size, moderate speeds, 3 PIN power, and Fixed RGB makes 1stPlayer R1 a practical, easy-to-integrate fan that gets the job done without unnecessary extras and complications.