Fan Fractal Momentum 14 RGB BLACK 3PACK 3 x 140mm Fans - FD-F-MR1-1403

Fractal Momentum 14 RGB BLACK 3PACK is a set of three 140 mm case fans aimed at mid-range and more serious gaming and enthusiast configurations. They combine a stable airflow of 74.39 CFM with Addressable RGB lighting, so you have both cooling and aesthetics. The 140 mm diameter allows for more air at lower speeds, and the dynamic fluid bearing keeps noise and vibrations under control. The black color and 7 blades provide a clean, streamlined look that easily fits with most builds.

What you get

With a range of 350 (±150) – 1800 rpm (± 10%), you can adjust the fans from nearly silent idle to serious airflow under load. With a maximum 2.45 mm H2O static pressure, these 140s perform well even behind denser mesh panels or filters, not just as "clean" intake/exhaust. The noise level up to 28 dBA is perfectly fine for gaming and work, especially if you use a fan curve in BIOS or through software. The 4-pin connector gives you PWM control for the speeds, while the separate 3-pin 5V ARGB connector allows for synchronization of the lighting with the motherboard or controller. The set of 3 units is fully sufficient to build meaningful airflow from the front and back/top in most mid-tower cases.

• Fans with a size of 140 mm, which means greater airflow at the same speeds compared to 120 mm variants.
• Speed range from 350 – 1800 rpm, allowing quiet operation in idle and aggressive cooling under load.
• Airflow up to 74.39 CFM, suitable for configurations with more serious heat dissipation.
• Maximum static pressure of 2.45 mm H2O, which helps air pass through filters and denser panels without losing efficiency.
• Noise level up to 28 dBA, a reasonable balance between cooling and acoustic comfort.
• Dynamic fluid bearing for longer life and less vibration compared to basic sleeve bearings.
• 4 PIN power for PWM control and 3 PIN 5V ARGB for addressable RGB, compatible with motherboard or external controller.
• Set of 3 fans in black color with 7 blades, ready to fill the main positions in a standard case.
• Current of 0.17 A at 12 V, which is well within the capabilities of standard fan headers.
• 24 months warranty, providing peace of mind for long-term use.

Who it is suitable for

This set is suitable if you are building a gaming or work build and want a meaningful balance between cooling, noise, and RGB aesthetics. It is suitable for mid-tower cases with positions for 140 mm fans – for example, 2 at the front as intake and one at the back or top as exhaust. If you are looking for completely unlit, maximum "stealth" fans or an extremely silent build at very low speeds, you might want to look at unbranded/unlit models, but as a universal solution, this set is quite flexible.

The most sensible thing here is the combination of 140 mm format, controllable speeds, decent static pressure, and ARGB in one 3-pack. You get a ready set for the whole case without thinking about what else to add, and you get both control, cooling, and organized aesthetics.